Differences between revisions 6 and 8 (spanning 2 versions)
Revision 6 as of 2013-01-05 22:49:58
Size: 1879
Editor: fungi
Comment:
Revision 8 as of 2013-01-05 22:57:42
Size: 2021
Editor: fungi
Comment:
Deletions are marked like this. Additions are marked like this.
Line 10: Line 10:
 * with modern iceweasel/firefox use Web Developer Extension -> Miscellaneous -> Clear Private Data -> Clear HTTP Authentication
Line 11: Line 12:
Steps... = Firmware Installation =
Line 27: Line 28:
 1. set root/admin as the new login
 1. disable both radios and choose Apply (Save is transient and does not write to NVRAM)
 1. with modern iceweasel/firefox use Web Developer Extension -> Miscellaneous -> Clear Private Data -> Clear HTTP Authentication
 1. set root/admin as the new login (we'll change it to something safe last thing)

= Initial Configuration =

 * '''Setup'''
 ** '''Basic Setup'''
 *** '''WAN Setup'''
 **** '''WAN Connection Type'''
 ***** '''Connection Type:''' ''Disabled''

Notes on the core switch build and configuration...

  • Cisco/Linksys E4200 v1
  • two for redundant operation
  • a third as a cold spare
  • higher-capacity power supplies
  • heatsinks and thermal adhesive for switch chips
  • DD-WRT standard
  • custom switch driver to allow 802.1q VLAN tag remapping

  • with modern iceweasel/firefox use Web Developer Extension -> Miscellaneous -> Clear Private Data -> Clear HTTP Authentication

Firmware Installation

  1. perform 30/30/30 reset
  2. connect as 192.168.1.2/30 to its WebUI through any LAN port

  3. initial login is root/admin
  4. upgrade flash with dd-wrt.v24-18777_NEWD-2_K2.6_mini-e4200.bin

  5. wait an additional five minutes for good measure
  6. perform 30/30/30 reset
  7. confirm password reset page is displayed

  8. set root/admin as the new login
  9. backup the CFE as routername_cfe.bin (in embeds the original interface MAC) and stash it somewhere for safekeeping
  10. upgrade flash with dd-wrt.v24-20453_NEWD-2_K2.6_std_usb_nas-nv60k.bin

  11. wait an additional five minutes for good measure
  12. perform 30/30/30 reset
  13. wait an additional five minutes for good measure
  14. confirm password reset page is displayed and Firmware: DD-WRT v24-sp2 (12/31/12) std-usb-nas shows in the top-right corner

  15. set root/admin as the new login (we'll change it to something safe last thing)

Initial Configuration

  • Setup

  • * Basic Setup

  • ** WAN Setup

  • *** WAN Connection Type

  • **** Connection Type: Disabled

CCL: Configuration/CoreSwitching (last edited 2014-08-31 23:32:39 by fungi)

CC0 To the extent possible under law, the creator of this work has waived all copyright and related or neighboring rights to it.