I used Fritzing to lay out a two-layer SpiffChorder development board and a submitted an order for the prototype to Fritzing Fab. The fabrication cost for one unit, including international shipping to the USA, was roughly US$40. I'll post pictures once it arrives in a couple weeks and I have a chance to run tests, but here are some preliminary details:

So far I'm using the same BoM from the perfboard design, but I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together:


The 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4" each. So as to be able to fit the four for CON3-4 directly adjacent to one another, I lightly sanded the facing sides until they fit snugly but evenly in a piece of perfboard. In an effort to make it easier to solder these evenly on the board, I attached their sides together with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves):

back to The Man-Machine...

CC0 To the extent possible under law, the creator of this work has waived all copyright and related or neighboring rights to it.