Differences between revisions 24 and 26 (spanning 2 versions)
Revision 24 as of 2012-06-18 02:58:16
Size: 2084
Editor: fungi
Comment:
Revision 26 as of 2012-06-18 03:10:05
Size: 2159
Editor: fungi
Comment:
Deletions are marked like this. Additions are marked like this.
Line 11: Line 11:
So far I'm using the same BoM from [[ManMachine/KeyerPerfboard|the perfboard design]], but I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. So far I'm using the same BoM from [[ManMachine/KeyerPerfboard#Bill of Materials|the perfboard design]], but I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole.
Line 16: Line 16:
[[attachment:SpiffChorderPaperTest.jpg|{{attachment:SpiffChorderPaperTestThumb.jpg|attachment:SpiffChorderPaperTest.jpg}}]] [[attachment:SpiffChorderPaperTest.jpg|{{attachment:SpiffChorderPaperTestThumb.jpg|SpiffChorder Paper Test}}]]
Line 19: Line 19:
Line 22: Line 21:
{{attachment:SpiffChorderScrewTerminalSanding.jpg}} {{attachment:SpiffChorderScrewTerminalsGlued.jpg}} {{attachment:SpiffChorderScrewTerminalSanding.jpg|SpiffChorder Screw Terminal Sanding}}
{{attachment:SpiffChorderScrewTerminalsGlued.jpg|SpiffChorder Screw Terminals Glued}}

Printed Circuit Board Layout

I used Fritzing to lay out a two-layer SpiffChorder development board and submitted an order for the prototype to Fritzing Fab. The fabrication cost for one unit, including international shipping to the USA, was roughly US$40. I'll post pictures once it arrives in a couple weeks and I have a chance to run tests, but here are some preliminary details:

Bill of Materials

So far I'm using the same BoM from the perfboard design, but I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole.

Paper Placement Test

Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together:

SpiffChorder Paper Test

Connector Detail

The 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4" each. So as to be able to fit the four for CON3-4 directly adjacent to one another, I lightly sanded the facing sides until they fit snugly but evenly in a piece of perfboard. In an effort to make it easier to solder these evenly on the board, I attached their sides together with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves):


back to The Man-Machine...

CCL: ManMachine/KeyerPCB (last edited 2012-07-02 21:40:29 by fungi)

CC0 To the extent possible under law, the creator of this work has waived all copyright and related or neighboring rights to it.