Differences between revisions 5 and 7 (spanning 2 versions)
⇤ ← Revision 5 as of 2013-01-05 22:44:22 →
Size: 1849
Editor: fungi
Comment:
← Revision 7 as of 2013-01-05 22:55:55 → ⇥
Size: 2019
Editor: fungi
Comment:
Deletions are marked like this. Additions are marked like this.
Line 10: Line 10:
 * with modern iceweasel/firefox use Web Developer Extension -> Miscellaneous -> Clear Private Data -> Clear HTTP Authentication
Line 11: Line 12:
Steps... = Firmware Installation =
Line 26: Line 27:
 1. confirm [[http://192.168.1.1/|password reset page]] is displayed and correct firmware load shows in the top-right corner
 1. set root/admin as the new login
 1. disable both radios and choose Apply (Save is transient and does not write to NVRAM)
 1. with modern iceweasel/firefox use Web Developer Extension -> Miscellaneous -> Clear Private Data -> Clear HTTP Authentication		  1. confirm [[http://192.168.1.1/|password reset page]] is displayed and ''Firmware: DD-WRT v24-sp2 (12/31/12) std-usb-nas'' shows in the top-right corner
 1. set root/admin as the new login (we'll change it to something safe last thing)

= Initial Configuration =

== Setup ==

=== Basic Setup ===

==== WAN Setup ====

===== WAN Connection Type =====

 * '''Connection Type:''' ''Disabled''

Notes on the core switch build and configuration...

  • Cisco/Linksys E4200 v1
  • two for redundant operation
  • a third as a cold spare
  • higher-capacity power supplies
  • heatsinks and thermal adhesive for switch chips
  • DD-WRT standard

  • custom switch driver to allow 802.1q VLAN tag remapping

  • with modern iceweasel/firefox use Web Developer Extension -> Miscellaneous -> Clear Private Data -> Clear HTTP Authentication

Firmware Installation

  1. perform 30/30/30 reset

  2. connect as 192.168.1.2/30 to its WebUI through any LAN port

  3. initial login is root/admin

  4. upgrade flash with dd-wrt.v24-18777_NEWD-2_K2.6_mini-e4200.bin

  5. wait an additional five minutes for good measure
  6. perform 30/30/30 reset

  7. confirm password reset page is displayed

  8. set root/admin as the new login
  9. backup the CFE as routername_cfe.bin (in embeds the original interface MAC) and stash it somewhere for safekeeping

  10. upgrade flash with dd-wrt.v24-20453_NEWD-2_K2.6_std_usb_nas-nv60k.bin

  11. wait an additional five minutes for good measure
  12. perform 30/30/30 reset
  13. wait an additional five minutes for good measure

  14. confirm password reset page is displayed and Firmware: DD-WRT v24-sp2 (12/31/12) std-usb-nas shows in the top-right corner

  15. set root/admin as the new login (we'll change it to something safe last thing)

Initial Configuration

Setup

Basic Setup

WAN Setup

WAN Connection Type

  • Connection Type: Disabled

CCL: Configuration/CoreSwitching (last edited 2014-08-31 23:32:39 by fungi)

CC0 To the extent possible under law, the creator of this work has waived all copyright and related or neighboring rights to it.