Differences between revisions 12 and 14 (spanning 2 versions)
Revision 12 as of 2012-06-17 19:41:06
Size: 1646
Editor: fungi
Comment:
Revision 14 as of 2012-06-17 19:51:37
Size: 1644
Editor: fungi
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
This printed circuit development board was laid out using [[http://fritzing.org/|Fritzing]], and an order has been placed to [[http://fab.fritzing.org/|Fritzing Fab]] for a prototype to QA. I'll post pictures once it arrives in a couple weeks, but here are some tidbits to tantalize: This two-layer development board was laid out using [[http://fritzing.org/|Fritzing]], and an order has been placed to [[http://fab.fritzing.org/|Fritzing Fab]] for a prototype to QA. I'll post pictures once it arrives in a couple weeks, but here are some tidbits to tantalize:
Line 7: Line 7:
So far I'm using the same BoM from [[../KeyerPerfboard|the perfboard design]]. Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together: So far I'm using the same BoM from [[../KeyerPerfboard|the perfboard design]], but I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together:
Line 11: Line 11:
I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. Also, the 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4", so I lightly sanded down the facing sides for CON3-4 until they fit snugly but evenly in a piece of perfboard and then attached them to one another with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves): Also, the 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4", so I lightly sanded down the facing sides for CON3-4 until they fit snugly but evenly in a piece of perfboard and then attached them to one another with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves):

This two-layer development board was laid out using Fritzing, and an order has been placed to Fritzing Fab for a prototype to QA. I'll post pictures once it arrives in a couple weeks, but here are some tidbits to tantalize:

So far I'm using the same BoM from the perfboard design, but I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together:

attachment:SpiffChorderPaperTest.jpg

Also, the 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4", so I lightly sanded down the facing sides for CON3-4 until they fit snugly but evenly in a piece of perfboard and then attached them to one another with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves):


back to The Man-Machine...

CCL: ManMachine/KeyerPCB (last edited 2012-07-02 21:40:29 by fungi)

CC0 To the extent possible under law, the creator of this work has waived all copyright and related or neighboring rights to it.