|
Size: 670
Comment:
|
Size: 1604
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 1: | Line 1: |
| The printed circuit version is in progress using [[http://fritzing.org/|Fritzing]], and an order has been placed to [[http://fab.fritzing.org/|Fritzing Fab]] for a prototype to QA. I'll post pictures once it arrives in a couple weeks, but here are some tidbits to tantalize: | This printed circuit development board was laid out using [[http://fritzing.org/|Fritzing]], and an order has been placed to [[http://fab.fritzing.org/|Fritzing Fab]] for a prototype to QA. I'll post pictures once it arrives in a couple weeks, but here are some tidbits to tantalize: |
| Line 6: | Line 6: |
So far I'm using the same BoM from [[../KeyerPerfboard|the perfboard design]]. Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together: [[attachment:SpiffChorderPaperTest.png|{{attachment:SpiffChorderPaperTestThumb.png||SpiffChorder Paper Test}}]] I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. Also, the 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4", so I lightly sanded down the facing sides until they fit snugly but evenly in a piece of perfboard and then attached them to one another with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves): [[attachment:SpiffChorderScrewTerminalSanding.png|{{attachment:SpiffChorderScrewTerminalSandingThumb.png||SpiffChorder Screw Terminal Sanding}}]] |
This printed circuit development board was laid out using Fritzing, and an order has been placed to Fritzing Fab for a prototype to QA. I'll post pictures once it arrives in a couple weeks, but here are some tidbits to tantalize:
Fritzing's schematic view (printed to PDF at 450x315mm no margins)
etchable PDF export (combined using pdfunite from poppler-utils)
So far I'm using the same BoM from the perfboard design. Here's a paper test using a 1:1 scale printout of the silkscreen and solder mask together:
I'll probably switch up CON1 with Digikey part 609-2845-ND (vertical rather than right-angle) so as not to block the lower-left mounting hole. Also, the 0.1" pitch right-angle screw terminal blocks I used are just slightly longer than 0.4", so I lightly sanded down the facing sides until they fit snugly but evenly in a piece of perfboard and then attached them to one another with a tiny dab of quick-setting adhesive gel (being careful not to get it into the terminals themselves):
To the extent possible under law, the creator of this work has waived all copyright and related or neighboring rights to it.
